column 7 of the hazardous materials table

US DOT's Hazardous Materials Regulations (HMR) list more than 3,000 shipping names for regulated materialsfrom acetal to zirconium tetrachloride. When such batteries are transported in accordance with 173.185(c), the total lithium content of all lithium metal cells contained in the battery must not exceed 1.5 g and the total capacity of all lithium ion cells contained in the battery must not exceed 10 Wh. 198 Nitrocellulose solutions containing not more than 20% nitrocellulose may be transported as paint, perfumery products, or printing ink, as applicable, provided the nitrocellulose contains no more 12.6% nitrogen (by dry mass). 332 Magnesium nitrate hexahydrate is not subject to the requirements of this subchapter. Mass detonate means more than 90 percent of the devices tested in a package explode practically simultaneously. ); and. Uranium hexafluoride may be classified under this entry only if the conditions of 173.420(a)(4) and (6) and (d) and 173.421(b) and (d) of this subchapter, and, for fissile-excepted material, the conditions of 173.453 of this subchapter are met. The purpose of this article is to explain the meaning of the coding system for the Special Provisions of column 7 in order to facilitate your review and understanding of them and how they may apply to your shipment of a hazardous material. b. In this case, some parts of the vehicle may be detached from its frame to fit into the packaging. A101 In addition to the applicable requirements of 173.185, the quantity of lithium metal in the batteries contained in any piece of equipment must not exceed 12 g per cell and 500 g per battery. N77 For materials of not more than two percent active ingredients by weight, packagings need not conform to the requirements of part 178 of this subchapter, if liquid contents are absorbed in an inert material. Column 7 of the 172.101 Hazmat Table lists the special provisions that apply to an individual proper shipping name. 21 This material must be stabilized by appropriate means (e.g., addition of chemical inhibitor, purging to remove oxygen) to prevent dangerous polymerization (see 173.21(f) of this subchapter). An important, but often overlooked, requirement for the safe and regulatory compliant transportation of a HazMat is an understanding of the special provisions in column 7 of the Hazardous Materials Table. f. The properties of mechanical strength mentioned in this special provision shall be tested using a prototype of a receptacle and/or dispenser filled to nominal capacity, by increasing the temperature until the specified pressures are reached. B65 Tank cars constructed before March 16, 2009, must have a test pressure of 34.47 Bar (500 psig) or greater and conform to Class 105A. Use of these proper shipping names for domestic shipments may be made only under a DOT special permit, as defined in, and in accordance with the requirements of subpart B of part 107 of this subchapter. The maximum degree of filling must not exceed the degree of filling determined by the following: tr is the maximum mean bulk temperature during transport, tf is the temperature in degrees celsius of the liquid during filling, and. (iii) Constructing the battery with terminals that are recessed or otherwise protected so that the terminals will not be subjected to damage if the package is dropped. If appropriate, a package containing this material must conform to the additional labeling requirements of 172.402 of this subchapter. TP36 For material assigned this portable tank special provision, portable tanks used to transport such material may be equipped with fusible elements in the vapor space of the portable tank. (1) Numeric provisions. 61 A chemical oxygen generator is spent if its means of ignition and all or a part of its chemical contents have been expended. b. (ii) One bottle for every two hours of production, or for every 2,500 bottles produced, must be tested by dropping a bottle filled to 98 percent capacity with water from a height of 1.2 meters (3.9 feet) onto solid concrete directly on the closure. Lading in unlined tanks must be inhibited so that the corrosive effect on steel is not greater than that of hydrofluoric acid of 65 percent concentration. Shipping papers at all times must reflect a correct current accounting of all cylinders both full and expended. This entry also applies to articles not conforming to the requirements of 173.302, 173.304, or 173.306 of this subchapter, containing a small pressure receptacle with a release device. In addition, packages shall be legibly and durably marked with an identification of the consignor, the consignee, or both. 351 Ammonium chlorate, ammonium chlorate aqueous solutions, and mixtures of a chlorate with an ammonium salt are forbidden for transport. TABLE 2 lists . B56 Water-tight, sift-proof, closed-top, metal-covered hopper cars are also authorized if the particle size of the hazardous material is not less than 149 microns. The present arrangement occurs in such a way that one QA molecule is hydrogen-bonded to four neighboring molecules: two different molecules in one column and other two molecules in another column. N76 For materials of not more than 25 percent active ingredient by weight, packages consisting of inner metal packagings not greater than 250 mL (8 ounces) capacity each, packed in strong outer packagings together with sufficient absorbent material to completely absorb the liquid contents are authorized and need not conform to the requirements of part 178 of this subchapter. See 173.306(h) of this subchapter. Additionally, the offeror must notify the carrier if the tank pressure rise exceeds 3 psig over any 24-hour period. Column 7 specifies codes for special provisions applicable to hazardous materials. Packaging must be UN standard metal drums attached with heavy duty steel strapping to a pallet; and. (9) W codes. The rechargeable lithium ion cells can only be charged from the primary lithium metal cells; ii. 56 A means to interrupt and prevent detonation of the detonator from initiating the detonating cord must be installed between each electric detonator and the detonating cord ends of the jet perforating guns before the charged jet perforating guns are offered for transportation. These requirements must be met in addition to the design and construction specifications in part 178 of this subchapter. g. The test results shall be documented, shall be traceable, and shall be made available to a representative of the Department upon request. ; and. The consignor shall be in possession of a copy of each applicable certificate when packages include fissile material excepted by competent authority approval. For a battery whose voltage (electrical potential) exceeds 9 volts -, (1) When contained in a device, the device must be packaged in a manner that prevents unintentional activation or must have an independent means of preventing unintentional activation (e.g., packaging restricts access to activation switch, switch caps or locks, recessed switches, trigger locks, temperature sensitive circuit breakers, etc. is the mean coefficient of cubical expansion of the liquid between the mean temperature of the liquid during filling (tf) and the maximum mean bulk temperature during transportation (tr) both in degrees celsius. When Column 7 refers to a special provision for a hazardous material, the meaning and requirements of that special provision are as set forth in 172.102 of this subpart. 115 Boosters with detonator, detonator assemblies and boosters with detonators in which the total explosive charge per unit does not exceed 25 g, and which will not mass detonate and undergo only limited propagation in the shipping package may be assigned to 1.4B classification code. Non-specification bulk bins are authorized. Except as otherwise provided in this subchapter, these special provisions do not apply to UN portable tanks or IBCs: B1 If the material has a flash point at or above 38 C (100 F) and below 93 C (200 F), then the bulk packaging requirements of 173.241 of this subchapter are applicable. Each inner packaging contains not more than 30 mL; b. A metal hydride storage system installed in or intended to be installed in a vehicle or equipment or in vehicle or equipment components must be approved for transport by the Associate Administrator. For transportation by aircraft, articles, machinery, or apparatus, may not contain any material forbidden for transportation by passenger or cargo aircraft. 238 Neutron radiation detectors: Neutron radiation detectors containing non-pressurized boron trifluoride gas in excess of 1 gram (0.035 ounces) and radiation detection systems containing such neutron radiation detectors as components may be transported by highway, rail, vessel, or cargo aircraft in accordance with the following: a. B25 Packagings must be made from monel or nickel or monel-lined or nickel-lined steel. TP38 Each portable tank must be insulated with an insulating material so that the overall thermal conductance at 15.5 C (60 F) is no more than 1.5333 kilojoules per hour per square meter per degree Celsius (0.075 Btu per hour per square foot per degree Fahrenheit) temperature differential. Tank car tanks must have a test pressure rating of 1,379 kPa (200 psig). (h) Column 7: Special provisions. A combination packaging consisting of a 4G fiberboard box with inner receptacles of glass or earthenware; b. Table 3 authorizes Large Packagings for specific proper shipping names through the use of IB Codes assigned in the 172.101 table of this subchapter. Each tank car must have a reclosing pressure relief device having a start-to-discharge pressure of 10.34 Bar (150 psig). TP27 A portable tank having a minimum test pressure of 4 bar (400 kPa) may be used provided the calculated test pressure is 4 bar or less based on the MAWP of the hazardous material, as defined in 178.275 of this subchapter, where the test pressure is 1.5 times the MAWP. B8 Packagings shall be made of nickel, stainless steel, or steel with nickel, stainless steel, lead or other suitable corrosion resistant metallic lining. f. Chemicals under pressure containing components forbidden for transport on both passenger and cargo aircraft in Columns (9A) and (9B) of the 172.101 Hazardous Materials Table must not be transported by air. A30 Ammonium permanganate is not authorized for transportation on aircraft. Testing must be performed or witnessed by a person who is approved by the Associate Administrator (see 173.56(b) of this subchapter). Do not enter until vapors have dissipated. The driver of the transport vehicle and the consignee(s) must be trained not to enter the transport vehicle until the ammonia vapors have dissipated, and the emergency response information on the shipping paper must indicate that the vehicle contains ammonia vapors. b. 1/1.1 See UN1210, UN1263, UN1266, UN3066, UN3469, and UN3470. b. 335 Mixtures of solids that are not subject to this subchapter and environmentally hazardous liquids or solids may be classified as Environmentally hazardous substances, solid, n.o.s, UN3077 and may be transported under this entry, provided there is no free liquid visible at the time the material is loaded or at the time the packaging or transport unit is closed. 150 This description may only be used for ammonium nitrate-based fertilizers. When a specific portable tank instruction is specified by a T Code in Column (7) of the 172.101 Table for a specific hazardous material, a specification portable tank conforming to an alternative tank instruction may be used if: (A) The alternative portable tank has a higher or equivalent test pressure (for example, 4 bar when 2.65 bar is specified); (B) The alternative portable tank has greater or equivalent wall thickness (for example, 10 mm when 6 mm is specified); (C) The alternative portable tank has a pressure relief device as specified in the T Code. 109 Rocket motors must be nonpropulsive in transportation unless approved in accordance with 173.56 of this subchapter. However this examination is required when the conditions of 180.605(f) are met. Hazardous materials necessary for the safe and proper operation of the cargo transport unit (e.g., fire extinguishing systems and air conditioning systems), must be properly secured to or installed in the cargo transport unit and are not otherwise subject to this subchapter. The battery has been tested as a primary lithium battery; and. An installed inflation cylinder that requires recharging must be filled in accordance with 173.301(l). e. When transported by highway, rail, vessel, or as cargo on an aircraft, neutron radiation detectors containing not more than 1 gram of boron trifluoride, including those with solder glass joints are not subject to any other requirements of this subchapter provided they meet the requirements in paragraph a of this special provision and are packed in accordance with paragraph b of this special provision.

Emmanuel Baptist Church Atlanta, 72 Most Dangerous Animals Africa, Rappers Who Smoke Cigarettes, Articles C